Adc SG-1 Instrukcja Użytkownika Strona 32

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 226
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 31
Chapter 4: Accessing the Command Line Interface June 30, 2006
4-2 SG1-UM-8500-03
SETTING THE IP ADDRESS
Set the management card IP address, subnet mask, and default gateway (if a gateway exists) to enable
communication with external networks and to enable access to the SG-1 CLI for Telnet sessions.
To set a new IP address and subnet mask for the SCC, do the following.
3 Press ENTER to initiate the terminal session.
4 Enter your user name at the Username: prompt.
5 Enter your password at the Password: prompt.
The system will display the Host> prompt:
Welcome to SG-1 System
Username: technician
Password: *****
Login Successful
Host>
Host> configure terminal
Host(config)# interface ethernet
Step Action
1 From the Host(config)# prompt, enter the interface command in the following format:
interface ethernet <slot number>\<port number> <ipaddr> <netmask> mode
<ethernet mode> [mtu <1500|1544>]
2 From the Host(config)# prompt, enter the ip default-gateway command in the following format:
ip default-gateway <ipaddr>
3 For this change to become permanent, the user must perform a write memory command from the
Host> first level prompt to save this change to NVRAM (when the save command is issued, it saves all
systems parameters):
write memory
Step Action
Przeglądanie stron 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 225 226

Komentarze do niniejszej Instrukcji

Brak uwag